TM 10-7360-226-13&P
0021 00
CONTAINERIZED KITCHEN (WITH TRAILER)
UNIT MAINTENANCE PROCEDURES
SEAL, DOOR
GASKET, DOOR
HM15LW
ON
Metro
POWER
MODULE (SEE FIGURE 3)
Figure 2. Mobile Warming Cabinet Maintenance.
Module
The module (Figure 3) is removed from the cabinet using the following procedure:
Make sure the power cord is unplugged and that the module has cooled to a temperature safe
for handling.
Open the bottom door. Remove the module by lifting the front enough to clear the detent, then
pull the module from the cabinet. The power cord should slip through the clearance hole in the
back of the cabinet.
Unfasten the electrical cover by removing the screws along the front bottom of the module and
the top panel. Remove the water pan from the top cover. Open the module by lifting the unit
from the chassis. Turn the unit over for access to the components.
Power Cord: Label and disconnect the power cord wires. Using pliers, squeeze the strain
relief from inside and push out.
Slip the replacement power cord through the strain relief and then through the mounting hole.
Connect the black and white wires and the green ground wire. Snap the strain relief in place.
0021 00-3
