TM 10-7360-226-13&P
CONTAINERIZED KITCHEN (WITH TRAILER)
UNIT MAINTENANCE PROCEDURES
OVEN ASSEMBLY
THIS SECTION COVERS:
Inspect, Test, Replace, Repair
INITIAL SETUP:
CK set up for operation
Power cables, fuel line disconnected
Maintenance Level
Unit
Tools and Special Tools
Tool Kit, General Mechanic's (WP 0052 00, Table 1, Item 1)
GENERAL
This procedure contains information and instructions for inspecting, testing and repairing the CK
Oven Assembly. Refer to WP 0037 00 for repair parts information.
INSPECT
Inspect the oven base, oven and fan assembly for loose hardware, damaged rivets and broken
or loose welds. Inspect base casters for smooth operation. Tighten loose hardware. Refer
broken or loose frame welds or damaged rivets to Direct Support maintenance.
TEST
Fuel Line: Refer to the troubleshooting procedures in the MBU manual to determine if the
problem with the MBU is caused by lack of fuel. Check the fuel line connection at the wall to the
Mechanical Room. Check all hose assemblies on the back of the oven assembly for signs of
fuel leakage. Replace the hose assembly using the replacement procedure in the following
section.
24 VDC Electrical Cable: Refer to the troubleshooting procedures in the MBU manual to
determine if the problem with the MBU is caused by an absence of 24 VDC. Remove the power
connector at the MBU and check for 24 VDC. If voltage is present, recheck the procedures in
the MBU manual. If 24 VDC is not present, unplug the connector from the ceiling raceway and
check voltage at the receptacle. If voltage is present, repair the cable using the repair
procedure in the next section. If voltage is not present refer to the test procedure in WP 0018
Casters: Attempt moving the Oven Assembly with the casters unlocked. It should move freely
without binding of the casters. Move the Oven Assembly in all directions to isolate the problem
to a particular caster. Check for foreign material in the caster flanges.
0020 00-1
Change 1
