TM 10-7360-226-13&P
0024 00
CONTAINERIZED KITCHEN (WITH TRAILER)
UNIT MAINTENANCE PROCEDURES
Install the replacement water heater, reinstall the mounting hardware, hoses, and the electrical
connector.
Pump Assembly: See Figure 2. To replace the pump assembly, label the wires and
disconnect the power cord at the junction box on the pump assembly mounting bracket.
Remove the four screws from the pump assembly mounting plate. Retain the rubber mounting
spacers.
Install the replacement pump, the four mounting spacers and screws on to the mounting plate.
Reconnect the power cord to the junction box.
Faucet: To replace the faucet, disconnect the hot and cold water supply lines under the sink.
Remove the nuts and washers from the faucet pipes and remove the faucet. Insert a
replacement faucet and reassemble the washers and nuts.
Hoses: If a water supply hose or the interior drain hose is damaged, replace it. If a washer or
gasket is damaged, remove it with a small screwdriver or needle nose pliers and replace it with
a new one.
END OF WORK PACKAGE
Change 2
0024 00-4
