TM 5-6350-255-13
should point to OFF.
Using an Allen wrench or
NOTE
equivalent, tighten the power switch knob with two set
While installing new switch, rotate shaft to its
screws to the power switch shaft.
maximum counterclockwise position, using
(5) Install switch cover, washer, nut, lanyard washer and
seals and hardware provided with switch.
cap to the interface connector, and replace all previously
Tighten securing nut with flat portion of shaft
removed modules.
facing C, 3, or ARM, as applicable.
(6) Turn power switch (fig. 5-2) to TEST or ARM and
check operation of the MINISID III.
(4) Install the knobs for the security switches so they
point to SET, and the knob for the power switch
5-19
