SB 740-94-8
APPENDIX E
QUALITY ASSURANCE INSPECTION INSTRUCTION
STORAGE SERVICABILITY STANDARD ADDENDUM
SERVICE KIT, PORTABLE FLAMETHROWER-RIOT
CONTROL AGENT DISPERSER, M27
TRC 4CD
TM 3-1040-221-12
Service Kit, Portable Flamethrower-
E-1. Purpose. This Quality Assurance Inspection
Riot Control Agent Disperser,
Instruction provides peculiar instructions and inspection
M27
requirements, in addition to those coded inspection
(2) Supply catalog.
requirements contained within appendix A for the items
SC1040-94-CL-E02
Service Kit, Portable Flamethrower-
listed below:
Riot Control Agent Disperser,
NSN
Nomenclature
M27.
1040-00-736-3230
Service
Kit,
Portable
Flame
b. Basis of Surveillance. Surveillance for the M27
thrower, Riot Control Agent
Riot Control Agent Disperser Service Kit and major
Disperser, M27
components shall be conducted on the basis of grand,
1040-00-605-6297
Test Gage Assembly, Pressure
Cylinder
manufacturer's, or miscellaneous lots. Miscellaneous lot
1040-00-654-5743
Test Gage Assembly, Fuel Tank,
size shall not exceed 500 items.
M2A1
c. Sampling. Sampling of lots shall be conducted
1040-00-859-2207
Hose Assembly, charging
as required by paragraph 2-4 and as follows:
1040-00-862-2540
Hose Assembly, pneumatic
(1) For visual examination.
The sample
1040-00-898-1284
Test Gage Assembly, Fuel Tank
quantity as indicated in the sampling plan, paragraph 2-
M9
1040-00-898-1285
Test Gage Assembly, Agent Tank,
4, shall be randomly selected from the lot.
M3
NOTE
Hose Assembly, Rubber
From the sample obtained for visual
Hose Assembly, Rubber
examination
of
the
applied
Hose Assembly, Rubber
packaging, packing, marking, and
E-2. Policy. The inspection requirements cited herein
preservation processes, a selection
supplement the coded inspection requirements
of samples for end item visual
contained within appendix A when the TRC of this
examination is permissible.
appendix (4CD) is referenced in the TRC column of
(2) For tests. Use MIL-STD-105, Inspection
Level S-1, AQL of 0.65 percent for sampling. The
be used with the coded requirements to provide an
acceptance number for critical defects is zero. Samples
effective surveillance inspection plan encompassing the
shall be randomly 'selected from the sample obtained
minimum inspection efforts that need be expended to
(1) above. If the visual inspection sample is the same
determine materiel serviceability with an acceptable
size as that required for testing, the entire sample shall
confidence level. The user shall not deviate from these
be subjected to test. Should the sample of visually
requirements without prior permission from the
acceptable items be smaller than that required for
Commander, US Army Armament Materiel Readiness
testing, additional samples shall be selected from the
Command, ATTN: DRSAR-QAE, Rock Island, IL 61299.
lot.
Also, provide copies of related correspondence to the
E-4. Inspection Procedure. Samples shall be visually
Commander, US Army Armament Research and
inspected for defects resulting from the applied
Development Command, ATTN: DRDAR-QAC-R,
packaging, packing, marking, and preservation
Aberdeen Proving Ground, MD 21010.
processes. The defects are identified in table E-1. The
E-3. Instructions. a. References.
end item samples shall be visually inspected for the
(1) Technical manual.
defects listed in Table E-2. Samples
E-1
