SB 740-94-8
failures to be considered as critical, wherein one item
of major component items shall be visually inspected for
the defects listed in tables E-3, E-4, E-5, E-6, E-7, and
failing the test would be cause for immediately
suspending the lot from issue and use, and the test
E-8. The required samples for testing of visually-
acceptable items shall be subjected to the applicable
failures to be considered as major, wherein acceptance
or rejection of the lot would be based on the acceptance
tests described in c below. Tables E-2 through E-10, in
number of the sampling plan.
addition to providing classification of visual defects,
provide classification of test failures. The classification
a. Classification of Defects for packaging, Packing,
of test failures is provided to differentiate between the
Marking, and Preservation.
test
Table E-1. Packaging, Packing, Marking, and Preservation, Service Kit M27, NSN 1040-00-736-3230
Category defect
Defect
Inspection method
No.
Critical
None defined.
Major:
101
Shipping or inner containers damaged, deteriorated, or weathered to the
Visual
extent that contents cannot be adequately protected and containers
require replacement.
102
Inner container wet or mildewed.
Visual
103
Loose pack (packing so loose that contents have been damaged or are
Visual
in
danger of being damaged).
Other
Refer to "Quality Defect Codes" in appendix A.
Visual
Minor:
201
Slight damage to shipping or inner containers but not affecting pro-
Visual
tection of contents.
Other
Refer to "Quality Defect Codes" in appendix A.
Visual
b. Classification of Defects for End Items.
Table E-2. Service Kit, Portable Flamethrower-Riot Control Agent, Disperser, M27 NSN 1040-00-736-3290
Category defect
Defect
Inspection method
No.
Critical:
1
Rubber hose assembly leakage-air pressure or hydrostatic pressure
Test, paragraph E-4c(1)
(refer to table E-7).
2
Rubber hose assembly-binding of spindle (refer to table E-7).
Test, paragraph E-4c(1)
3
Fuel tank test gage assembly leakage (refer to tables E-3 and E-5).
Test, paragraph E-4c(2)
4
Agent tank test gage assembly leakage (refer to table E-6).
Test, paragraph E-4c(3)
5
Pressure cylinder test gage assembly, leakage (refer to table E-4).
Test, paragraph E-4c(4)
6
Flexible low pressure hose leakage (refer to table E-8).
Test, paragraph E-4c(5)
Major:
101
Pressure gage out of calibration (refer to tables E-4, E-5, and E-6).
Test, paragraph E-4c(2),
(3), and (4)
102
Component missing (refer to TM 3-1040-221-12).
Visual
Other
Refer to "Quality Defect Codes" in appendix A.
Visual
Minor:
Refer to "Quality Defect Codes" in appendix A.
Visual
Table E-3. Test Gage Assembly, Fuel Tank, M2A1 NSN 1040-00-654-5743
Category defect
Defect
Inspection method
No.
Critical
1
Leakage test failure.
Test paragraph E-4ci2)
Major.
101
Pressure gage out of calibration.
Test, paragraph E-4c(21
Other
Refer to "Quality Defect Codes" in appendix A.
Visual
Minor.
Refer to "Quality Defect Codes "in appendix A.
Visual
E-2
