TM 10-3510-208-12
Figure 2-11. Air compressor starting.
with water, then replace the priming plug. Push
(4) Water Heater and Water Pump Starting
the water pump switch to the ON position.
Instructions.
(c) Make certain the float holddown rod is
(a) Push the water pump power switch
in the released position.
(located on the frame of the engine-generator) to
(d) Open the water heater vent valve and
the ON position.
keep it open until a steady stream of water flows
(b) Remove the priming plug, fill pump
from the vent drain pipe.
2-17
Change 7
