TM 10-3510-208-34
b. Cleaning.
WARNING
Clean all parts in a well-ventilated
area. Avoid inhalation of solvent
fumes and prolonged exposure of
skin to cleaning solvent. Wash
exposed
skin
thoroughly.
Dry
cleaning solvent (Fed. Spec. P-D-
680) used to clean parts is potentially
dangerous
to
personnel
and
property. Do not use near open
flame or excessive heat. Flash point
of solvent is 100 to 138F. (38 to
59C.).
Clean all metal parts with cleaning solvent, Fed.
Spec. P-D-680, and dry thoroughly.
c. Inspection and Repair.
(1) Inspect the base for cracks, breaks,
dents and other damage.
(2) Weld minor cracks or breaks; replace
unrepairable base.
(3) Inspect all other parts for damage and
make replacement as necessary.
d. Assembly and Installation.
(1) Install the washer-extractor base (17, fig.
7-8) and secure with lockwashers (14 and 16),
capscrews (13 and 15), lockwashers (12), flatwashers
(11), lockwashers (10) and nuts (9).
(2) Install the compression springs (7 and
8), if removed.
(3)
Install
the
shock
absorbers
(6),
grommets (5), flatwashers (4), bolts (3), grommets (2)
and nuts (1).
7-8. Washer Motor
a. Removal. Refer to figure 7-9 and remove the
washer motor.
7-18
