TM 10-3510-208-34
Figure 2-7. DC volts scale (sheet 3 of 3).
3. To measure 24 volts DC, set
selector switch to "V/DC 50" position. (If measuring less
and 10 volts DC, set selector switch to "V/DC 10"
position. If measuring less than 2.5 volts DC, set
selector switch to "V/DC 2.5" position).
4. Set polarity reversing switch to
the "DC" position.
(2)
Set polarity reversing switch to the " DC"
position.
(a)
Set up multimeter (paragraph (1)
above).
NOTE
If you are unsure of the voltage to be
measured on the equipment, always
start on the highest range. This will
protect the meter.
(b)
With all three multimeters, connect
the red probe to the positive ( ) side of the circuit and
the black probe to the negative (-) side. The example
(fig. 2-8) shows 24 volts DC being measured across the
batteries.
2-13
