TM 10-3510-209-24
2-22.1. WASHER CONTROLLER ASSEMBLY (CONT)
2.
Removal of knob and knob shaft extension.
a.
Loosen set screw (11A) and remove knob (11) and rubber grommet (11B).
b.
Remove nine screws (2) from top panel (3) of washer controller and remove panel (3).
c.
Through open top of washer controller loosen alien set screw (11C) on knob shaft extension (11D) and
remove knob shaft extension.
INSTALLATION
1.
Installation of window.
Position new window (29), warning plate (27), nameplate (26) and lamp socket assembly (23) and secure with eight
screws (22) and nuts (20).
2.
Installation of knob and knob shaft extension.
a.
Position knob shaft extension (11D) on drum shaft and tighten allen set screw (11C) through open top of
washer controller unit.
b.
Position rubber grommet (11B) on knob shaft extension (11D), halfway through hole in side of washer
controller.
c.
Place knob (11) on shaft extension (11D) and tighten allen set screw (11A).
d.
Place top panel (3) on top of washer controller and secure with nine screws (2).
2-86.2 Change 1
