TM 10-3510-209-24
2-22. WASHER DRIVEBELT
This task covers:
a. Inspection
b. Service
c. Replacement
d. Adjustment
INITIAL SETUP
Tools
General Safety Instructions
General mechanic's tool set,
SC 5180-90
WARNING
High voltage is present on this equipment. Do not perform
Personnel Required
maintenance with power on. Death or serious injury may result.
MOS 63J (1)
Equipment Condition
Materials/Parts
TM 10-3510-209-10, Washer drained.
Lubricating oil (Item 17, App C)
TM 10-6115-585-12, Generator off.
TM 10-3510-209-10, Water pump removed.
Paragraph 2-16, Front basket assembly removed.
INSPECTION
WARNING
High voltage is present on this
equipment.
Do
not
perform
maintenance with power on. Death
or serious injury may result.
1.
Remove electrical power from the washer.
2.
Lift up on drivebelt cover (1), slide cover away I
from top mounting brackets (2), and remove cover.
3.
Inspect drivebelt (3) for wear, fraying, signs of
slipping, and incorrect tension. Refer to ADJUSTMENT,
step 6.
4.
Turn drive pulley (4) by hand. Feel for rough
movement or binding of gears or motor bearings.
5.
Remove oil level hole plug (5). Check oil level
(even with bottom of hole). Replace plug (LO
10-3510-209-12).
2-84.2 Change 1
