TM 10-3510-209-24
2-22. WASHER DRIVEBELT (CONT)
INSPECTION (Cont)
6.
Install drivebelt cover (1) on mounting bracket (2).
SERVICE
Lubricate gear reduction unit in accordance with LO 10-3510-209-12.
REPLACEMENT
1.
Remove electrical power from the washer.
2.
Lift up on the drivebelt cover (1), slide cover away from top mounting bracket (2) and remove cover.
3.
Loosen the two locking nuts (6) that secure the adjustment bolts (7) to motor mounting plate (8).
4.
Loosen two pivot bolts (9A) (front and rear).
5.
Loosen two adjustment nuts (9) as necessary to remove drivebelt.
6.
Drop motor and remove old drivebelt. Replace with new drivebelt.
7.
Perform ADJUSTMENT procedures that follow.
ADJUSTMENT
WARNING
High voltage is present on this equipment. Do not perform maintenance with
power on. Death or serious injury may result.
1.
Remove electrical power from the washer.
2.
Lift up on drivebelt cover (1), slide cover away
from top mounting bracket (2), and remove cover.
3.
Loosen the two locking nuts (6) that secure the
adjustment bolts (7) to motor mounting plate (8).
4.
Loosen two pivot bolts (9A) (front and rear).
CAUTION
Motor must remain level throughout
adjustment of belt tension to prevent
excessive belt wear caused by an
improperly aligned pulley.
5.
Increase tension on the drivebelt by evenly
turning two adjustment nuts (9) on the motor base plate
counterclockwise.
6.
Decrease tension on the drivebelt by evenly
turning two adjustment nuts (9) on the motor base plate
clockwise.
Change 1 2-85
