TM 55-1945-205-24-4
2-41. DRYER ASSEMBLY (CONT)
REPAIR (Cont)
I.
Pull wires (63) through conduit (67) and install conduit in solenoid (65).
m.
Install solenoid (65) on bracket (66) and secure with two mounting screws (64).
n.
Connect wires (63) to terminals in junction box (62).
o.
Install cover (61) on junction box (62) and tighten with two screws (60).
p.
Connect two fuel lines (58) to nipples (59).
q.
Open fuel shutoff valve (55).
4.
Repair dryer door assembly.
NOTE
Repair door assembly by replacing
the unserviceable door with a new
one.
a.
Open dryer door (69).
b.
Remove pin (70) from center of door hinge
(71).
CAUTION
Support the door while removing the
hinge rod.
c.
Drive hinge rod (72) down through door
hinge (71).
d.
If hinge rod (72) is being replaced, loosen
setscrew (73) and remove door switch
cam (74) from the bottom of the hinge rod
and install it on the new hinge rod.
e.
Position new dryer door (69) on the dryer,
align door hinge (71), and drive hinge rod
(72) into the hinge from the bottom.
Change 1 2-151
