TM 10-3510-209-24
Table 2-2. Unit Troubleshooting (Continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
38.
WASHER CYLINDER WILL NOT ROTATE (AUTOMATIC OR MANUAL MODE).
Step 1.
Check for blown fuse on controller assembly.
a.
If fuse is blown, replace fuse.
b.
If fuse is serviceable, proceed to next step.
Step 2.
Check for loose or slipping drivebelt.
a.
If drivebelt is loose or slipping, adjust drivebelt for proper
tension. Refer to paragraph 2-22.
b.
If drivebelt is properly adjusted and problem persists, notify
your supervisor.
39.
WATER LEAKS AROUND WASHER DOOR.
Step 1.
Check for damaged door gasket.
a.
If door gasket is damaged and needs replacement, notify your
supervisor.
b.
If door gasket is serviceable, proceed to next step.
Step 2.
Check for warped or damaged door.
a.
If door is damaged and needs replacement, notify your
supervisor.
b.
If door is serviceable, proceed to next step.
Step 3.
Check for damaged glass or glass gasket.
If glass or glass gasket is defective and needs replacement, notify
your supervisor.
2-54
