TM 10-3510-209-24
2-20. WASHER ASSEMBLY (CONT)
NOTE
Take care not to drop loose hardware down into washer.
4.
Remove two screws (12), nuts (14) and nylon washers (13) from mounting bracket (10).
5.
Unscrew temperature probe (15) at bushing (16) from rear of washer. Feed temperature probe and cable out
through hole and rear of washer frame.
NOTE
To help reassembly, note how the cable is routed through rear of washer frame
before removal.
6.
Route replacement temperature probe (15) with cable attached through hole in rear washer frame.
7.
Screw temperature probe (15) into bushing (16) on rear of washer.
8.
Secure mounting bracket (10) to soap chute (9A) using two screws (12), nuts (14) and nylon washers (13).
9.
Reinstall soap chute guard (9) with four screws (6) to inside of soap chute (9A).
10.
Install washer drivebelt cover (para 2-22) and water pump (TM 10-3510-209-10).
Change 1 2-76.1