TM 10-3510-209-24
2-20. WASHER ASSEMBLY (CONT)
ADJUSTMENT (Cont)
NOTE
The door interlock cam is adjusted so that when the door is closed and secured,
the contact button on the safety switch is pressed.
b.
Adjust the door interlock cam (4) by bending it in the desired direction (in or out).
c.
Slowly open and close the door. Listen for safety switch (3) to click on and off just as the door begins to
open.
d.
Repeat steps b and c until safety switch (3) is adjusted correctly.
2.
Adjust low water fill level.
CAUTION
Do not use tools to move speed nuts.
Position by hand. Damage to
equipment could result.
a.
Select low water level and allow washer to
fill.
b.
Adjust low water level for a depth of
approximately 7 inches (17.8 cm).
c.
To raise the low level, move low level
speed nut (5) down on float rod (6). Do
not position speed nut (5) closer than 1
inch (2.5 cm) to high level speed nut (7).
d.
To lower the low level, move low level
speed nut (5) up on float rod (6). Do not
position speed nut (5) closer than 1 inch
(2.5 cm) to high level speed nut (7).
e.
Drain washer.
f.
Repeat steps (a) thru (e) until a low level
of approximately 7 inches (17.8 cm) is
reached.
2-77
