TM 10-3510-209-24
2-20. WASHER ASSEMBLY (CONT)
ADJUSTMENT (Cont)
3.
Adjust high water fill level.
CAUTION
Do not use tools to move speed nuts.
Position by hand. Damage to
equipment could result.
a.
Select high water level and allow washer
to fill.
b.
Adjust high water level for a depth of
approximately 11 inches (28 cm).
c.
To raise the high level, move high level
speed nut (7) down on float rod (6). Do
not position speed nut (7) closer than 1
inch (2.5 cm) to low level speed nut (5).
d.
To lower the high level, move high level
speed nut (5) up on float rod (6). Do not
position speed nut (7) closer than 1 inch
(2.5 cm) to low level speed nut (5).
e.
Drain washer.
f.
Repeat steps (a) thru (e) until a high level
of approximately 11 inches (28 cm) is
reached.
2-78
