TM 10-3510-220-10
2-7.
SITE SELECTION, SETUP, AND ASSEMBLY. (CONT)
(3) Connect the other ends of fuel lines (2) to drum fill adapter (7). The
line from the fuel filter connects to fitting labeled SUPPLY on the
drum fill adapter. The line from the bottom of fuel pump connects to
fitting labeled RETURN on the drum fill adapter.
NOTE
The drum fill adapter can be used with 55--
gallon (208 liter) drums (6), 5-gallon (19 liter)
cans (4), or other fuel sources.
(4) If a 55-gallon (208 liter) drum (6) is being used as the fuel source,
remove drum fill adapter extension (5) from the bottom of the return
port and install it in the drum fill adapter pipe. When using 5-gallon
(19 liter) cans (4), the extension remains attached to the return port.
h.
Make exhaust hose connections as follows:
WARNING
Carbon monoxide is dangerous. Ensure that
exhausts are properly vented to an open-air
area. Death or serious injury to personnel can
result from heavy exposure to exhaust gas.
(1) Unhook three straps (1, figure 2-15) and remove combustion exhaust
ducts (2) from trailer assembly (3).
Be sure that exhaust ducts (1, 3, 5, and 7,
figure 2-16) do not touch or cross other exhaust
ducts, power cables, fuel lines, or water hoses.
Melting/damage can occur causing leaking fuel
and water or electrical hazards, Death by
electrocution, fire, or explosion could result,
(2) Connect 5-inch (127 mm) combustion exhaust duct (1, figure 2-16) to
dryer exhaust port (2). Extend duct away from trailer assembly. Do
not touch or cross other exhaust ducts, power cables, water hoses, or
fuel lines
NOTE
The dryer lint duct is stored inside the dryer
assembly during transportation.
(3) Obtain 12-inch (305 mm) lint duct (3) and installon dryer lint duct port
(4). Fully extend duct along right side of trailer. Do not touch or cross
other exhaust ducts, power cables, water hoses, or fuel lines.
2-47
WARNING
