TM 10-3510-220-10
2-7.
2-8.
SITE SELECTION, SETUP, AND ASSEMBLY. (CONT)
(4) Connect two 7-inch (178 mm) combustion exhaust ducts (5) together
and connect to water heater exhaust port (6). Extend duct full length
away from rear of trailer.
Do not touch or cross other exhaust ducts,
power cables, water hoses, or fuel lines.
(5) Connect two 2-inch combustion exhaust ducts (7) to generator exhaust
Ports (8). Extend ducts away from trailer assembly. Do not touch or
cross other exhaust ducts, power
PREPARATION FOR USE.
a. Generator.
Ensure that the ON/OFF
heater are in the OFF position and that all circuit
are turned off.
cables, water hoses, or fuel lines.
switch on the water pump and water
breakers in the power distribution box
Figure 2-15.
Exhaust Duct Removal From Trailer.
2-48
