TM 10-3510-220-24
2-40. WATER MANIFOLD ASSEMBLY (CONT)
DISASSEMBLY (Cont)
a. Remove locknut (25), and bolt (26) from crank (24).
b. Remove cotter key (38), shims (40), spacer (37) and pin (39). Slide air actuated ball valve
assembly (16 or 34) off of bolt (41).
c. Remove nuts (42 and 43), washers (44 and 45), bolts (46 and 47) and remove anchor bracket
(15) from nipple (6 or 36).
d. Remove nipple (6 or 36) from air actuated ball valve assembly (16 or 34).
REPAIR
Replace any broken or defective fittings or parts.
ASSEMBLY
NOTE
Use thread sealing compound on all connections to prevent leaks.
1. To assemble nipple (6 or 36) onto the air actuated ball valve assembly (16 or 34), perform the
following:
a. Install nipple (6 or 36) into air actuated ball valve assembly (16 or 34).
b. Install anchor bracket (15) on nipple (6 or 36). Do not tighten bolts (46 and 47) or nuts (42 and
43) until adjustment procedures are complete.
c. Place air actuated ball valve assembly (16 or 34) with shims (40) and spacer (37) onto pin (39)
and install cotter key (38).
d. Tighten locknut (25) and bolt (26) to secure crank (24).
e. Perform adjustment procedures then tighten bolts (46 and 47) and nuts (42 and 43).
2-139
