TM 10-3510-220-24
2-49. DRYER AIR SHUTTER ASSEMBLY (CONT)
REPAIR
NOTE
A cracked housing or flange can be
repaired by proper welding procedures.
1. Replace shutter (3)
and/or blower impeller
(15) if damaged.
2. Use a wire brush and
remove accumulated matter
from filter screen (7).
3.
INSTALLATION
1.
2.
3.
4.
5.
6.
7.
8.
Replace missing or damaged hardware.
Install gasket (21) and flange (12) on motor (8) and secure with four lockwashers (13) and
capscrews (14).
Install key (9) on shaft of motor (8).
Install blower impeller (15) on shaft of motor (8) and tighten setscrews (16).
Install coupling (19) on shaft of motor (8) and tighten setscrews (18).
Position blower housing (17) on flange (12) and secure with eight lockwashers (11) and fan
capscrews (10). Tighten clamp (20).
Install filter screen (7) and air intake housing (6) onto blower housing (17) and secure with four
lockwashers (5) and capscrews (4).
Install shutter (3) on air intake housing (6) and secure with thumbscrew (1) and nut (2).
Perform follow-on installation.
Install tarp assembly (TM 10-3510-220-10).
2-176
