TM 10-3510-220-24
3-23. DRYER TUMBLER ASSEMBLY (CONT)
REMOVAL (Cont)
6.
Remove conduit nut (14) from elbow (22) and
wires (7). Remove elbow and wires from control
box (13).
WARNING
Components of the dryer are heavy and maybe
awkward to handle. Use correct lifting procedu
lifting devices, and/or assistance from other
personnel to avoid injury.
7.
Remove 16 bolts (21), flat washers (20),
16 flatwashers (19), lockwashers (18) and 11
nuts (17) and dryer (16) from trailer (15).
INSTALLATION
1.
2.
3.
4.
5.
6.
7.
8.
WARNING
res,
Components of the dryer are heavy and maybe
awkward to handle. Use correct lifting procedures,
lifting devices, and/or assistance from other
personnel to avoid injury.
Install dryer (16), 16 bolts (21), 15 flat
washers (20), 16 flatwashers (19),
lockwashers (18), and 11 nuts (17)
on trailer (15).
WARNING
High voltage is present on this equipment. Do not
perform maintenance with power on. Death or serious
injury may result.
Install wires (7) and elbow (22) in
control box (13) and install conduit
nut (14).
Connect wires (7) to terminal board (8) and tighten screws (9). Remove tags.
Connect ground wire (12) and install washer (10) and nut (11).
Install plastic wire ties (Item 11, App C) as required.
Install cover plate (6) and three screws (3), lockwashers (4), and flatwashers (5).
Close control panel door (2) and tighten three screws (1).
Perform follow-on installation. Install platform (TM 10-3510-220-10). Install left beam (para
2-15). Install tarp assembly (TM 10-3510-220-10).
3-109
