TM 10-3510-220-24
3-25. DRYER UV SCANNER AND FLAME SAFEGUARD ASSEMBLY
This task covers:
a. Test
b. Service
c. Repair
d. Replace
INITIAL SETUP
Equipment Condition
Tools
TM 10-3510-220-10, Tarp assembly and
General mechanic’s tool kit
platform removed.
General Safety Instructions
Materials/Parts
WARNING
Flame controller UVM2 (72144)
Wiping cloth,
High voltage is present on this equipment. Do
(Item 3, App C)
not perform maintenance with power on.
Death or serious injury may result.
WARNING
Remove rings, bracelets, wristwatches, and
neck chains before working around or on the
laundry unit. Jewelry can catch on
equipment and cause injury, or may short
across an electrical circuit and cause severe
burns or electrical shock.
TEST
WARNING
High voltage is present on the equipment. Do not perform maintenance
with power on, Death or serious injury may result.
1.
2.
3.
4.
Prepare dryer for operation
(TM 10-3510-220-10).
Turn on fuel and power.
Wait approximately 20 seconds. If
audible alarm sounds, go to step 10.
If blower motor does not come on and
ignition does not occur, go to next step.
Remove thumbscrews (1) and open
dryer control box door (2) and check motor
contractors (3). If contractors are tripped, reset
contractors and check for normal operation.
If contactors continue to trip, test motor
contactor operation (step 5). If contractors are
not tripped go to (step 6).
3-114
