TM 10--3510--221--24
0053 00--1
CONDENSATE TEMPERATURE LO
0053 00
THIS WORK PACKAGE COVERS:
Troubleshooting Condensate Temperature Lo Fault
INITIAL SETUP:
Maintenance Level
Materials/Parts
Unit
Tools and Special Tools
Equipment Conditions
Tool Kit, General Mechanics (Item 1, WP 0272 00)
Power must be applied at main control
enclosure (WP 0010 00).
NOTE
Perform this procedure only when ”CONDENSATE TEMP LO” message is displayed for
continuous periods of 30 minutes or longer.
1. At end of a normal laundry cycle observe operator panel display.
Does display read ”CONDENSATE WATER TEMP LO”?
YES Go to step 2.
NO Return to normal operation.
2. Observe operator panel display.
Does display read ”LT200 FAILURE”?
YES Go to Typical LT FAILURE (WP 0033 00).
NO Go to step 3.
3. Start a laundry cycle and wait for cycle to get to ”EXTRACT TO RINSE 1” step.
4. Using EXAMINE INPUTS mode monitor still temperature (TE200)
Is TE200 reading > 211 degrees F?
YES Go to step 6.
NO Go to step 5.
5. Using EXAMINE INPUTS mode monitor heater TF temperature (TE300)
Is TE300 reading > 250 degrees F?
YES Go to 6.
NO Go to HEATING SYSTEM FAILURE (WP 0072 00).
6. Perform cooldown cycle (TM 10--3510--221--10).
7. Position SW1 and SW2 to OFF.
8. Check integrity of insulation on steam piping between still and still condenser.
Is insulation properly covering steam piping?
YES Go to step 9.
NO Repair as necessary.
