TM 10--3510--221--24
0119 00--2
DRUM BALANCE SWITCH REPLACEMENT --
Continued
0119 00
INSTALLATION
1. Position switch (6) onto adjustment bracket (7), then secure with two screws (3), flat washers (4), and nuts (5).
2. Connect electrical connector (2) to switch cable (1).
3. Secure switch cable (1) with tiedown straps.
ADJUSTMENT
1. Use maintenance menu to pressurize air bags (WP 0010 00).
2. Measure distance from top of outlet duct (8) to switch tip (9). If distance is 1/4 to 3/8 inches proceed to step 4,
otherwise continued to step 3.
3. Adjust position of switch (6) as follows:
a. Loosen two screws (3).
b. Readjust position of switch (6) to obtain proper distance between switch tip (9) and outlet duct (8).
c. Tighten two screws (3).
4. Perform a test laundry cycle (TM 10--3510--221--10). Verify smooth operation of drum.
END OF WORK PACKAGE