TM 10--3510--221--24
0145 00--1
DRUM INLET VALVE REPLACEMENT
0145 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Maintenance Level
Materials/Parts
Unit
Tags (Item 9, WP 0271 00)
Tape, Anti--Seizing (Item 10, WP 0271 00)
Washer, Lock (Item 26, WP 0275 00)
Tools and Special Tools
Equipment Conditions
Tool Kit, General Mechanics (Item 1, WP 0272 00)
LADS power shut off at main control
enclosure (WP 0112 00).
Air pressure must be vented (WP 0113 00).
REMOVAL
1. Remove cap (1) from outlet piping A or B (2). Allow residual water to drain then reinstall cap.
2. Tag and disconnect tubes (3) from elbows (4) on control valve (5).
3. Remove two screws (6) and nuts (7).
4. Remove two screws (8) and nuts (9).
5. Pull flange (10) out from between bracket (11) and valve body (12).
6. Remove valve body (12) and adapter (13).
7. Remove four screws (14) and lock washers (15) then remove actuator (16) from mounting bracket (17).
8. Remove elbows (4) from actuator (16).
9. Clean anti--seizing tape from threads of elbows (4).
