TM 10--3510--221--24
0143 00--1
FRONT--TO--BACK VIBRATION ELIMINATOR
REPLACEMENT
0143 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Maintenance Level
Materials/Parts
Unit
Washer, Lock (Item 27, WP 0275 00)
Washer, Lock (Item 30, WP 0275 00)
Tools and Special Tools
Equipment Conditions
Tool Kit, General Mechanics (Item 1, WP 0272 00)
LADS power shut off at main control
enclosure (WP 0112 00).
REMOVAL
WARNING
Keep hands and feet clear of drums when venting air bags. Failure to follow this precaution
could result in severe personnel injury.
1. Vent air pressure from air bags (1) as follows:
a. Disengage two latches (2), then open access door (3).
b. Close manual valve (4).
c. Open petcock (5).
d. Open petcocks (6) on front air bags (1).
e. Allow air pressure to vent from air bags (1) then close petcocks (5 and 6).
NOTE
Step 2 applies only to rear vibration eliminator.
2. Remove two screws (7), lock washers (8), and nuts (9), then remove stop bracket (10) from bearing support
(11).
3. Remove two screws (12), flat washers (13), lock washers (14), and nuts (15), then remove vibration eliminator
(16) from pedestal (17).
