TM 10--3510--221--24
0146 00--3/4 blank
DRUM OUTLET VALVE REPLACEMENT -- Continued
0146 00
INSTALLATION
1. Apply anti--seizing tape to threads of elbows (2).
2. Apply thread sealant to threads of barb fittings (6 and 9) and piping (15).
3. Thread piping (15) into inlet port of new control valve (3) as shown.
4. Thread barb fitting (6) into piping (15).
5. Thread barb fitting (9) into control valve (3).
6. Install elbows (2) into control valve (3).
7. Position control valve (3) with attached piping (15) onto ISO frame (16).
8. Connect hose (5) at barb fitting (6) then tighten clamp (4).
9. Connect hose (8) at barb fitting (9) then tighten clamp (7).
10. slide coupling (11) onto piping (15) then tighten clamps (10).
11. Install and tighten pipe clamps (13 and 14).
12. Connect tubes (1) to elbows (2) as tagged.
10. Perform a test laundry cycle (TM 10--3510--221--10). Visually check for water leaks while laundry cycle is
underway.
END OF WORK PACKAGE
