TM 10--3510--221--24
0158 00--2
DOOR POSITION SWITCH REPLACEMENT --
Continued
0158 00
INSTALLATION
NOTE
When installing position switch (1) side edge of switch should be aligned with side edge of
actuator (5).
1. Locate new position switch (1) on mounting bracket (4), then secure with two screws (2) and lock washers (3).
2. Unless already accomplished, close door (5) as follows:
a. Swing door (5) closed. Ensure door is tight against still (6).
b. Pivot clamping knob (7) onto door arm (8) then hand tighten until door arm is approximately 1/8 inch
behind mounting angle (9).
3. Check alignment between side edge of position switch (1) and side edge of actuator (5). Realign switch if
necessary.
4. Connect leadwires of position switch (1) as tagged.
ADJUSTMENT
1. Measure gap between position switch (1) and actuator (10). It should be 1/8 to 1/4 inches. If gap is not correct
continue to step 2, otherwise proceed to step 3.
2. Adjust position of actuator (10) as follows:
a. Loosen two screws (11) securing actuator (10) to door arm (8).
b. Slide actuator (10) in or out to achieve proper gap then tighten screws (11).
c. Check gap between position switch (1) and actuator (10). Repeat steps a and b as necessary.
3. Using maintenance menu to access examine inputs function (WP 0010 00), verify correct operation of position
switch (1) as follows:
a. Verify position switch ZS200 status is ON.
b. Loosen clamping knob (7) and pivot off of door arm (8).
c. Swing door (5) open.
d. Verify position switch ZS200 status is OFF.
4. Close door (5) as follows:
a. Swing door (5) closed. Ensure door is tight against still (7).
b. Pivot clamping knob (7) onto door arm (8) then hand tighten until door arm is approximately 1/8 inch
behind mountinging angle (9).
END OF WORK PACKAGE
