TM 10--3510--221--24
0214 00--3/4 blank
ANALOG TO DIGITAL CONVERTER PCB
REPLACEMENT -- Continued
0214 00
INSTALLATION
1. ESD. Slide new analog to digital converter PCB (4) into card cage rack (5). Make sure PCB is fully seated.
2. ESD. Connect ribbon cable (6) to cable header (7).
3. ESD. Slide retaining plate (2) forward and tighten two screws (1).
4. Turn handle (8) CW, then close door (9).
5. Secure door (9) to main control enclosure (10) by tightening eleven latches (11).
6. Perform DAILY START--UP and a test LAUNDRY CYCLE (TM 10--3510--221--10). Verify normal operation.
END OF WORK PACKAGE