TM 10-3510-222-24
2-28. LOCK COVER AND LOCK - continued.
(c) Position bar (27) on new door solenoid (31) and install screw (26), washer (25), washer (24) and nut (23).
(d) Position door solenoid (31) on bracket (16) and install two screws (30), washers (29) and nuts (28).
(3) Door Switch (20).
(a) Remove two screws (17), gasket (18) and strike plate (19).
(b) Remove switch (20) and insulator (21) from latch strike (22).
(c) Position latch strike (22), insulator (21), new switch (20), strike plate (19), gasket (18) and install two
screws (17).
c. INSTALLATION
(1) Lock (4)
(a) Apply plumbing fixture setting compound around the four mounting holes on washer that the screws (32)
will be installed in.
(b) Position lock (4) on washer door (15) and install four screws (32).
(c) Install lock cover (3).
(2) Lock Cover (3).
(a) Position connector (9), new washer (8) on lock cover (3) and install nut (7).
NOTE
Wire numbers are stamped on each electrical wire. This information, in conjunction with data on
FO-2 Washer Wiring Diagram, may be used to connect wires if tags are lost or illegible.
(b) Connect electrical wiring (5) with two connectors (6).
(c) Position lock cover (3) on lock (4).
(d) Install four screws (1) and washers (2) on lock cover (3).
d. ADJUSTMENT
(1) Manually retract bar (27) and open washer door (15).
(2) Loosen two screws (12) on latch strike (14).
(3) Place paper material between door and washer and close door.
(4) Pull on paper material, it should barely move, adjust by turning screw (13) in or out.
(5) Manually retract bar (27) and open washer door (15).
(6) Tighten screws (12) on latch strike (14).
(7) Install lock cover (3).
2-75
