TM 10-3510-222-24
2-30. MOTOR AND PLATE - continued.
b. INSTALLATION
(1) AC Motor (8)
(a) Remove four screws (6) and cover (7) on ac motor (8).
(b) Position ac motor (8) on plate (13).
(c) Install four bolts (12), lockwashers (11) and nuts (10) on ac motor (8) and plate (13).
NOTE
Wire numbers are stamped on each electrical wire. This information, in conjunction with data on
FO-2 Washer Wiring Diagram, may be used to connect wires if tags are lost or illegible.
(d) Position motor (8) on washer.
(e) Connect conduit (9) and wiring to ac motor (8).
(f) Install cover (7) on ac motor (8) and install four screws (6).
(g) Position key (16) and pulley (5) on ac motor (8) at same distance pulley (5) was removed.
(h) Install bushing (15) and two bolts (14).
(i) Install V-belt (4) on pulley (5 and 17).
(j) Proceed to adjustment.
c. ADJUSTMENT
NOTE
V-belt deflection is measured midway between motor pulley and gear box pulley.
(1) Measure V-belt (4) deflection of one inch (2.54 cm) from center of V-belt.
(2) If less than one inch, do substeps below:
(a) Loosen four nuts (1) on screws (2) if not already loose.
(b) Turn four nuts (3) until one inch deflection is achieved on V-belt (4).
(c) Tighten four nuts (1) on screws (2) and plate (13).
(3) If more than one inch, do substeps below:
(a) Loosen four nuts (1) on screws (2) if not already loose.
(b) Turn four nuts (3) until one inch deflection is achieved on V-belt (4).
(c) Tighten four nuts (1) on screws (2) and plate (13).
2-80
