TM 10-3510-222-24
3-24. REDUCER AND OUTPUT QUILL.
This task covers:
a. Removal
b. Disassembly
c. Cleaning
d. Inspection
e. Repair
f. Assembly
g. Installation
INITIAL SETUP
Tools
Equipment Condition
General Mechanics Tool Kit (App B, Item 1)
V-belt removed (Para 2-30)
Automotive Vehicle Shop Equipment
(App B, Item 3)
Personnel Required
Two
Materials/Parts
Seal (App C, Item 41)
NOTE
Seal (App C, Item 42)
For seal replacement only, see
Cleaning Cloth (App D, Item 3)
REMOVAL and INSTALLATION
Drycleaning Solvent (App D, Item 10)
Adhesive (RTV) (App D, Item 1)
Suitable Bucket
Manila Folder
Lubricant (See LO 10-3510-222-12 for reducer)
Shims (App C, Item 11, 12, 19, 23, 25, 27, 28 and 29)
a. REMOVAL
(1)
Remove two allen screws (1) from collar (2) and remove collar (2).
(2)
With a scribe, mark front position of bushing (9) on reducer input shaft (19).
(3)
Measure distance between bushing (9) and reducer (20) and record distance.
(4)
Remove two bolts (8) and lockwasher (18) from bushing (9).
(5)
Remove bushing (9) from pulley (10).
(6)
Remove pulley (10) from reducer input shaft (19).
(7)
Remove key (11) from reducer input shaft (19).
(8)
Loosen three allen screws (3) from front of reducer (20) and three allen screws (3) on back side of reducer (20).
NOTE
Flat washers are between plate and frame for alignment of reducer.
(9)
Record position of flat washers (7) under plate (17).
(10)
With a scribe, mark position of plate (17) on frame (21).
(11)
Remove four bolts (4), lockwashers (5) and flat washers (6) from plate (17) and frame (21).
3-40
