TM 10-3510-222-24
3-24. REDUCER AND OUTPUT QUILL - continued.
(12)
Remove reducer (20) from basket shaft (16).
(13)
Remove key (15) if basket shaft (16) is being replaced.
(14)
To remove seals, perform the following:
(a)
Remove V-belt (Para 2-30).
(b)
Remove seals (43) and/or (59) if leaking from cover (60). Discard seals (43 and/or 59).
(c)
Remove reducer (20) if rear seal (53) is leaking.
(d)
Remove seal (53) if leaking from cover (52). Discard seal (53).
b. DISASSEMBLY
(1)
With a scribe, mark position of plate (17) on reducer (20).
(2)
Remove four bolts (12), lockwashers (13) and flat washers (14) from reducer (20).
(3)
Remove reducer (20) from plate (17).
NOTE
Do not lay reducer on its side, lubricant will drain out of reducer.
(4)
If removing reducer for an internal problem, drain lubricant per substeps below:
(a)
Place container under drain plug (29).
(b)
Remove drain plug (29).
(c)
Remove breather (22).
(d)
When all lubricant has drained from reducer (20), install breather (22) and plug (29).
(5)
Remove ten nuts (26), flat washers (25), flat washers (24) and bolts (23) from reducer (20).
(6)
Position reducer (20) with input shaft (19) on top and remove cover (60) from cover (52).
(7)
Remove gears as assembly (55, 56 and 57).
(8)
Remove key (49) from gear (48).
(9)
Remove gears as assembly (46, 47, 48 and 50).
(10)
Remove key (40) from output quill (39).
(11)
Remove gears as assembly (37, 38 and 41).
(12)
Remove seal (53) from cover (52).
(13)
Remove seals (43 and 59) from cover (60).
c. CLEANING
WARNING
Drycleaning solvent is flammable and toxic to eyes, skin, and respiratory tract. Skin/eye
protection is required. Avoid repeated/prolonged contact. Use only in well-ventilated areas.
3-44
