TM 10-3510-222-24
3-24. REDUCER AND OUTPUT QUILL - continued.
f.
ASSEMBLY
(1)
Install gears as assembly (37, 38, 40 and 41).
(2)
Install gears as assembly (46, 47, 48, 49 and 50).
(3)
Install gears as assembly (55, 56 and 57).
(4)
Apply adhesive to mating surface of cover (52).
(5)
Install cover (60) on cover (52).
(6)
Install ten flat washers (24), bolts (23), flat washers (25) and nuts (26) on reducer (20).
(7)
Install seal (59) on cover (60).
(8)
Cut two pieces of manila folder two inches by ten inches. Apply lubricant on paper and wrap paper
around output quill (39).
(9)
Install seals (43 and 53) on cover (52 and 60) and remove paper.
(10)
Position plate (17) on marked position of reducer (20) and install four flat washers (14), lockwashers
(13) and bolts (12).
(11)
Install key (11) on reducer input shaft (19).
(12)
Install pulley (10) on reducer input shaft (19).
(13)
Install bushing (9) on reducer input shaft (19) at marked position.
(14)
Install two bolts (8) and lockwasher (18) on bushing (9).
g.
INSTALLATION
(1)
Install key (15) on basket shaft (16) if removed.
(2)
Position reducer (20) on basket shaft (16).
(3)
Position flat washers (7) for alignment between plate (17) and frame (21).
(4)
Install four flat washers (6), lockwashers (5) and bolts (4) on plate (17) and frame (21).
(5)
Tighten three allen screws (3) on front of reducer (20) and three allen screws (3) on back side of
reducer (20).
(6)
Position collar (2) index pin in index hole of basket shaft (16) and install two allen screws (1).
(7)
Service reducer (20), refer to LO 10-3510-222-12 Lubrication Order.
(8)
Install V-belt (Para 2-30).
3-47
