TM 10-3510-222-24
3-47. EXTRACTOR BRAKE - continued.
(21)
Remove nut (53), lockwasher (54) and stud (55).
(22)
Remove screw (56), lockwashers (57) and pivot bracket (58).
b.
REPAIR
Repair consists of replacing damaged and/or missing components of the extractor brake.
c.
ASSEMBLY
(1)
Position bracket (58) on oil drive housing (60) and loosely install lockwashers (57) and screws (56).
(2)
Position stud (55) on oil drive housing (60) and secure with lockwasher (54) and nut (53).
(3)
Position flat washer (51) and bell crank (50) on stud (55). Install grease fitting (52) on bell crank (50).
(4)
Position stud (49) on bell crank (50) and secure with lockwasher (48) and nut (47).
(5)
Position bracket (46) on bell crank (50) and install screw (44) and nut (45).
(6)
Position stud (43) on drive housing (60) and install pin (42).
(7)
Position plate (40) on oil drive housing (60) and secure with two spacers (41), lockwashers (39) and
screws (38).
(8)
Position solenoid (35) on plate (40) and secure with four lockwashers (37) and screws (36).
NOTE
Wire numbers are stamped on each electrical wire.
This information, in conjunction with data on FO-3
Extractor Unit Wiring Diagram, may be used to
connect wires if tags are lost or illegible.
(9)
If removed, connect wires to solenoid (35) as tagged.
(10)
Position three grommets (21 and 22) and link (23) on solenoid (35) and install shoulder pin (20) with cotter pin
(19).
(11)
Thread nut (30) about halfway up on screw (31) and install screw in arm (29).
(12)
Install nuts (24 and 26) and hook (25) on arm (29).
(13)
Connect hook (25) to link (23).
(14)
Position arm (29) on stud (55). Secure with flat washer (28) and nut (27).
(15)
Install hook (34) and nuts (33 and 32) on bracket (58).
(16)
Install spring (3), connecting it to bell crank (50) and hook (34). Tighten screw (56) and install screw (1) and
lockwasher (2).
(17)
Install bracket (18) on plate (40) with two flat washers (17), lockwashers (16) and screws (15).
(18)
Position key (14), drum (13) and setscrews (10) on drive shaft (59) and tighten two setscrews (12).
(19)
Install seal (9), basket ball (8) and insert (7).
(20)
Position brake shoe (6) on studs (43 and 49) and install flat washers (5) and clips (4).
(21)
Install curb and basket (Para 2-39).
(22)
Adjust brake (TM 10-3510-222-10).
3-110