TM 10-3510-224-13&P
0009 00
Table 1. Preventive Maintenance Checks and Services for the CSSL-Continued.
0009 00-7
Item
No.
Interval
Item to be
checked or
serviced
Procedure
Equipment not ready/available if:
27
After
Exterior GFCI
Receptacle
Check that the connection is secure.
Check for missing or damaged hardware.
Notify Unit Maintenance of any damage to
the GFCI receptacle.
Damaged receptacle, loose connector, missing
hardware.
28
Weekly
Washers/Dryers
Open each washer (1) to determine if
they contain water that has not drained
properly, or any clothing or other items. If
necessary, drain any water by activating
the washer. Check, and if needed, clean
out the dryer lint traps (4). Check the
attachment and general condition of the
dryer exhaust ducts (5). Verify that the
washer mounting is secure.
Not ready if Washer/Dryer mounting is not
secure. Connections are loose or damaged.
29
Weekly
Water Service
Panel
Check the freshwater panel (6) and the
wastewater panel (7) for damage, leaks
and corrosion.
Not ready if panel, hoses or fittings are
damaged or corroded.
30
Weekly
Interior Lights
Check for loose, damaged or missing
covers or mounting clips. Check for non-
functioning lights or light switch. Notify
Unit Maintenance of defective light switch.
Lights or light switch inoperative.
33
Weekly
Power Entry Panel Ensure connectors are secure and that
no damage has occurred to the panel
(13). Notify Unit Maintenance of any
damage to the panel or to the connectors.
Damaged panel or connectors. Improper or
loose connections. Missing or damaged
hardware.
34
Weekly
TEMPER Modified
Endwall Boot
Check for security and condition of straps
and hook and pile closures. Check for
torn fabric or frayed cinch straps.
Torn fabric, loose damaged or missing straps.
35
Weekly
Circuit Breakers
Check for tripped circuit breaker(s).
Reset the tripped circuit breaker(s).
If the Breaker trips again notify Unit
Maintenance. Check for security of
connections. Check for damaged or
missing hardware. Push the TEST button.
Observe the indicator light. If the indicator
light does not activate, push the RESET
button. Repeat the test. If the receptacle
does not work, replace it as described in
WP 0029 00.
Circuit Breaker(s) inoperative.
