TM 10-3510-224-13&P
0009 00
0009 00-3
Before Operation PMCS Checks and Services.
INITIAL SETUP:
Equipment Condition
CSSL set-up, water and power connected
Materials/Parts
Rags (WP 0070, Table 1, Item 1)
Fluorescent light bulbs (WP 0070, Table 1, Item 2)
Maintenance Level
Operator/Unit
Tools and Special Tools
None
Table 1. Preventive Maintenance Checks and Services for the CSSL.
Item
No.
Interval
Item to be
checked or
serviced
Procedure
Equipment not ready/available if:
1
Before
Washers/Dryers
Open washers (1) to determine if they
contain any water that has not drained
properly, clothes, or other items. Drain
water by activating washer. (If problem
persists, notify Unit Maintenance. Check
the condition and proper attachment of
the water supply (2) and wastewater drain
(3) hoses. Check for leaks. Check and, if
needed, clean out dryer lint traps (4).
Check for secure attachment and general
condition of dryer ducts (5).
Washers contain water of previous wash cycle,
clothes or other items. Dryers that contain
clothes or other items. Dryer lint traps are
clogged. Dryer exhaust hoses loose, clogged
or damaged. Water supply or drain hoses
loose, damaged or missing. Washers leak.
2
Before
Water Service
Panels
Check the freshwater (6) and wastewater
(7) panels for physical damage, leaks and
corrosion.
Panels or QD fittings are damaged. Hoses are
improperly connected and leaking. Excessive
corrosion.
3
Before
Interior Lights
Activate interior lights (8) and check if
they operate. Replace any burned out
light bulbs (9) (Refer to WP 0015 00).Refer
inoperative light switch or inoperative light
fixtures to Unit Maintenance.
Light fixtures inoperative, light switch, and
excessive number of light bulbs burned out.
4
Before
Vent Fan
Activate Vent fan (10) by switching to
EXHAUST for 30 seconds. Switch back to
OFF. Switch to INTAKE for 30 seconds.
Switch back to OFF. Refer an inoperative
vent fan to Unit Maintenance
Vent fan inoperative. Noisy operation.
5
Before
Space Heater
Activate space heater (11) and check for
proper operation. Check for functioning of
the heater control (12). Check for any
damage to the unit.
Heater control inoperative, damage to space
heater.
6
Before
Power Entry Panel Check for physical damage to panel (13)
connectors and cables (14). Ensure
cables are properly connected. (Refer to
Work Package 0005 00).
Damaged panel or connectors. Improper or
loose electrical connections.
