TM 10-3510-226-23
0011 00
BOILER TROUBLESHOOTING PROCEDURES-CONTINUED
Table 1. Boiler Troubleshooting Procedures for Containerized Batch Laundry Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Provide sufficient fuel of the
8. Boiler Burner Cutout
Check fuel source (Figure 8, Item 1)
correct type (JP-8, DF-1 or DF-
Alarm
and supply; check hoses; if using 55
2).
gallon drum, ensure pickup extension
is connected.
If fuel stream is solid, with no air
Bleed burner fuel pump IAW WP 0068
spitting, go to remove nozzle
assembly under the Test or
fuel delivery to burner.
Inspection column on this page.
Clean strainer. Refer to WP
Inspect burner fuel pump strainer
0068 00 as necessary.
00 as necessary.
Replace fuel filter element.
Ensure fuel filter (Figure 8, Item 4) is
Replace nozzle. Refer to WP
not clogged. Refer to WP 0069 00 as
0069 00 as necessary.
necessary.
Adjust or replace electrodes as
Remove nozzle assembly and inspect
necessary. Refer to WP 0068
electrodes (Figure 8, Item 5). Refer
to WP 0068 00 as necessary.
Clean or replace CAD cell IAW
Check CAD cell (Figure 8, Item 6) for
procedures given in WP 0068 00
soot on lens.
and WP 0069 00 as necessary.
Replace inoperative transformer.
Test transformer (Figure 8, Item 7)
If transformer is good, replace
IAW procedures given in WP 0068 00.
controller. Refer to WP 0069 00
as necessary.
Replace an inoperative exhaust
Check exhaust gas sensor (air switch)
gas sensor (air switch) IAW WP
Replace inoperative draft
Check draft inducer fan (Figure 8,
inducer fan IAW WP 0071 00.
If further corrective action is
required, notify direct support
maintenance.
Change 1
0011 00-12
