TM 10-3510-226-23
UNIT MAINTENANCE
CONTAINERIZED BATCH LAUNDRY
NSN 3510-01-527-2209
NSN 3510-01-527-2210
PROGRAMMABLE LOGIC CONTROL (PLC)
TEST
INITIAL SETUP
Tools
Personnel Required
Tool Kit, General Mechanics: Automotive (WP
Quartermaster and Chemical Equipment Repairer 63J
(1)
Materials/Parts
Equipment Condition
Wire Markers (WP0087 00, Item 58)
CBL operating
References
TM 10-3510-226-10
TEST
Selecting the System Info Display
CAUTION
Use extreme caution when accessing system information functions. Unauthorized or
careless use of these functions could render the PLC inoperative. In the event this
happens the CBL may still be operated manually.
CAUTION
Unless instructed otherwise in this manual, use a bare or gloved finger to operate the
PLC touch screen. Use of writing instruments, screws, nails, or metal tools may damage
the touch screen, rendering the PLC inoperative.
NOTE
When operating the touch screens on the PLC, use light finger pressure to operate
switches and menus.
NOTE
Many system information screens are password protected. These screens access setup
functions for the PLC, and should not be accessed by the maintainer. Only those
screens accessible to the maintainer are addressed here.
The PLC is programmed to control and monitor the operation of the CBL. The functions are selected
through separate displays presented on the PLC screen. The displays may be selected by touching the
tab at the top of the screen.
1. When the PLC is powered up, the SYSTEM CONTROL display (Figure 1, Item 1) is presented. If a
SYSTEM INFO function is desired, touch the SYSTEM INFO tab (Figure 1, Item 2) to access the
screen. An indicator bar or highlight will indicate that the SYSTEM INFO screen is presented.
