TM 10-3510-226-23
UNIT MAINTENANCE
CONTAINERIZED BATCH LAUNDRY
NSN 3510-01-527-2209
NSN 3510-01-527-2210
MOTOR
TEST, REPLACE
INITIAL SETUP
Tools
Personnel Required
Shop Equipment, Automotive Maintenance and
Quartermaster and Chemical Equipment Repairer 63J
Repair: Organizational Maintenance, Common
(2)
No.1 (WP 0086 00, Table 2, Item 5)
Equipment Condition
Straps
CBL set up
Materials/Parts
Wire Markers (WP 0087 00, Item 58)
References
TEST
Test the Washer Motor
WARNING
Ensure that all electrical power is shut off and disconnected before proceeding. The
Circuit Breaker box should be locked by personnel following this procedure. Serious
injury or death can result from electrocution if proper safety precautions are not observed.
WARNING
The washer is extremely heavy. Use caution when lifting and blocking the washer, and
do not allow unnecessary personnel in the immediate area while it is being moved.
Serious injury or death may result if safety precautions are not observed.
CAUTION
The washer is a large, heavy piece of machinery being moved out of a confined space.
Before removal and installation, remove or protect any equipment that might be damaged
by the washer on its way in or out.
1. Remove the cover from the variable frequency drive (Figure 1, Item 1) IAW procedures given in WP
2. Tag and disconnect the wiring from the 1, 2, and 3 terminals (Figure 1, Item 2) on the variable
frequency drive.
3. Use an ohmmeter to test for 1 to 3 ohms resistance between each wire.
4. Reconnect wiring as tagged.
5. Install all removed components IAW procedures given in WP 0041 00.
