TM 10-7360-226-13&P
0006 00
CONTAINERIZED KITCHEN (WITH TRAILER)
OPERATION UNDER USUAL CONDITIONS
WARNING
Ensure that all CK components have completely cooled
before initiating packout, or personal injury may result.
1. Turn off all MBUs and the water heater and allow the equipment to cool. If they were recently
used, the steam table, tray pack heater and water heater will contain hot water that may take
an hour or more to cool.
2. Remove all food and trash from the kitchen and clean the utensils, pots, pans, griddle, grease
filters, grease cup, grease trap, table tops, etc. as necessary. Place the clean utensils in the
baking/roasting pans.
3. Turn off the refrigerators and mobile warming cabinet and clean them.
4. Turn off the cook center ventilation. The generator, lights and ECU may be left on if desired.
5. Disconnect both ends of the water supply hose and internal drain hose. Drain the supply hose,
coil it tightly, and connect its two ends together to minimize the possibility of contamination.
Pack the supply hose on the lower shelf of the sink assembly. If it is not needed to drain the
steam table, coil the internal drain hose and pack it in the back of the sink assembly.
6. If necessary, drain the steam table after it has cooled. Connect the internal drain hose to the
steam table drain connection and the floor drain connection. Remove the stopper and allow
the table to drain. Replace the stopper when draining is complete. Disconnect the drain hose,
coil it, and pack it in the back of the sink assembly. If necessary, remove the floor drain cover
and clean the drain.
7. After it has cooled, drain the water heater. Open both faucet valves, both drain valves (located
under the water heater) and collect the water in a suitable container. Close all of the valves
when draining is complete. The collected water can be poured into the floor drain.
8. If the tray pack heater must be drained, leave the external drain hose in place it will be
removed later. If not, disconnect the hose and drain it. Coil it tightly, and pack it on the lower
shelf of the sink assembly. Install the cap on the external drain connection.
Change 2
0006 00-26
