SB 740-94-8
in the remarks section, Part II, Block 11 (see para 2-9a)
should be selected at random from that manufacturer's
lot.
of DA Form 984.
f. Sample Disposition.
2-5. Inspection. All inspections and test shall be
(1) Samples packaged in barrier material,
conducted under the control of a qualified inspector.
which have been inspected and resealed with a sealing
The inspections and tests normally will be conducted at
iron shall be identified as reinspected items in the
the surveillance inspection area; however, when
inspection records.
authorized, examinations or tests may be performed at
(2) Barrier material shall be resealed in
the storage site or elsewhere, but must be within the
accordance with instructions furnished with the material,
limitations of all safety and security requirements.
printed on the material, or furnished with the sealing
a. Initial Receipt Inspection (IR).
iron.
(1) Frequency.
This inspection shall be
(3) Serviceable samples shall be returned to
performed on an occurrence basis.
storage with the parent lot.
(2) Classification of defects. Table 2-1 shall
(4) Samples with critical or major defects or
be used to evaluate the incoming materiel.
samples which cannot be returned to the original
package configuration shall be segregated and reported
Table 2-1. Initial Receipt Inspection (IR)
Category defect No.
Defect
Inspection method
Critical:
None defined
Major:
101
Item damaged.
Visual
102
Packing, preservation, or packaging damaged to the extent that adequate
Visual
protection is no longer afforded to the item or handling and storing
would be adversely affected.
103
Item packing or packaging contaminated, wet, or mildewed.
Visual
Minor:
201
Slight damage to packing or packaging.
Visual
(3) Reporting. Initial Receipt inspection shall
(2) Examination and test.
When the
be reported on DA Form 984. In addition, failure data
serviceability status is unknown, the examination and
and discrepancies encountered will be reported on SF
test shall be performed in accordance with appendix A
368 (Quality Deficiency Report) per AR 702-7.
and the applicable appendix (TRC) for the item. All lots
b. Prestorage inspection (PS).
shall be examined for receipt condition using table 2-2.
(1) Frequency.
This inspection shall be
performed on an occurrence basis.
Table 2-2. Prestorage Inspection (PS)
Category defect No.
Defect
Inspection method
Critical:
None defined.
Major:
101
Item damaged.
Visual
102
Item packing or packaging contaminated, wet, or mildewed as a result of
Visual
adverse shipping conditions.
103
Packing or packaging damaged or deteriorated to the extent that adequate
Visual
protection is no longer afforded to the item or handling and storing
would be adversely affected.
104
Preservation, packing, packaging, or marking incorrect.
Visual
Minor:
201
Slight damage to packing or packaging.
Visual
(3) Reporting, Prestorage inspection shall be
(1) Frequency.
This inspection shall be
reported on DA Form 984 (see para 2-9(a) (1)).
performed at the frequency indicated (IFC) in appendix
c. Periodic Cycle Inspection (P).
(2) Examination and test. Examination and
test shall be performed in accordance with appendix
2-3
