TM 10-3510-208-12
1. Nut
5. Nut
8. Bracket
2. Washer
6. Washer
9. Screw
10. Locking plate
3. Screw
7. Screw
4. Bracket
11. Guard
Figure 4-31. Jackshaft guard removal and installation (Edro Model EP120-LTU).
(1) Edro Model (EP120-LTU).
in place and secure to motor base with locking
Clean all parts in a well-ventilated area.
plate (10) and screws (9).
Avoid inhalation of solvent fumes and
prolonged exposure of skin to cleaning
(b) Bend tangs on locking plate (10) up over
screws (9) .
solvent, Wash exposed skin thoroughly.
Dry cleaning solvent (Fed. Spec. P-D-680)
(c) Secure guard to lower support bracket
used to clean parts is potentially dangerous
(8), using screws (7), washers (6), and nuts (5).
(d) Secure guard to upper support bracket
to personnel and property. Do not use near
(4) with screws (3), washers (2) and nuts (1).
open flame or excessive heat. Flash point
(2) Eidal Model (ELT9T).
of solvent is 100 to 138F. (38 to 59C.).
Clean the jackshaft guards with cleaning
in place and secure to motor base with locking
solvent, Fed. Spec. P-D-680, and dry thoroughly.
c. Inspection and Repair.
plate (9), washers (8), and screws (7).
(1) Inspect the jackshaft guards for damage.
(b) Secure guard to washer base and
jackshaft pillow block with washers (6), bolts (5),
(2) Replace damaged jackshaft guards.
washers (4) and nuts (3).
d. Installation.
4-40