TM 10-3510-208-12
Figure 4-29. Washer Extractor Main Drive Guard removal and installation.
4-25. Jackshaft Guard
a Removal
Clean all parts in a well-ventilated area.
(1) Eidal Model (ELT9T)
Avoid inhalation of solvent fumes and
(a) Disconnect lubrication lines (1 and 2,
prolonged exposure of skin to cleaning
solvent. Wash exposed skin thoroughly.
(b) Remove nuts (3), washers (4), bolts (5),
Dry cleaning solvent (Fed. Spec. P-D-680)
and washers (6) securing jackshaft guard to
used to clean parts is potentially dangerous
jackshaft pillow block and washer base.
to personnel and property. Do not use near
(c) Remove screws (7), washers (8) and
open flame or excessive heat. Flash point
locking plate (9) securing jackshaft guard to the
of solvent is 100 to 138F. (38 to 59C. ).
washer base.
Clean the washer extractor main drive guard
(d) Remove jackshaft guard (10).
with cleaning solvent, Fed. Spec. P-D-680 and dry
(2) Edro Model (EP120-LTU)
thoroughly .
c. Inspection and Repair.
and screws (3) securing jackshaft guard to the
(1) Inspect washer extractor main drive guard
upper support bracket (4).
for cracks, breaks, dents, or distortion.
(b) Remove nuts (5), washers (6), and
(2) Weld cracks or breaks, straighten dents
screws (7) securing jackshaft guard to the lower
and distortion and/or replace damaged guard.
support bracket (8).
d. Installation
(c) Bend tangs on locking plate down and
Refer to figure 4-29 and install the washer
remove screws (9) and locking plate (10) securing
extractor hydro-sheave drive guard onto the
jackshaft guard to the motor base.
laundry unit.
(d) Remove jackshaft guard (11).
4-38
