TM 10-3510-209-24
2-45. DRYER FUEL PUMP ASSEMBLY (CONT)
ASSEMBLY
1.
Install bleed valve (37) and plug (38) in fuel
pump body (39).
2.
Install pressure adjusting screw (36) in end plug
assembly (33).
3.
Install spring (30), sleeve (29), sleeve retainer
(28), gasket (27), and end plug (26), or fuel
pump body (39).
4.
Install spring seat (35), gasket (34), end plug
assembly (33), gasket (32), and acorn nut (31)
on fuel pump body (39).
5.
Install gasket (19) and port housing (18).
6.
Install shaft assembly (25) and then install seal
(24), seal washer (23), seal spring (22), seal cup
(21), and seal cap (20).
7.
Install spacer plate assembly (17) and end plate
assembly (16) and secure with five screws (15).
8.
Install strainer (13) and anti-hum wafer (14).
9.
Install gasket (12) and cover (11) and secure
with eight capscrews (10).
2-164
