TM 10-3510-209-24
2-45. DRYER FUEL PUMP ASSEMBLY (CONT)
DISASSEMBLY (Cont)
4.
Remove seal cap (20), seal cup (21), seal spring
(22), seal washer (23), and seal (24). Remove
shaft assembly (25).
5.
Remove end plug (26), gasket (27), sleeve
retainer (28), sleeve (29), and spring (30) from
fuel pump body (39).
6.
Remove acorn nut (31), gasket (32), end plug
assembly (33), gasket (34), and spring seat (35)
from fuel pump body (39).
7.
Remove pressure adjusting screw (36) from end
plug assembly (33).
8.
Remove bleed valve (37) and plug (38) from fuel
pump body (39).
REPAIR
1.
Inspect all parts for wear and damage.
2.
Use replacement kit to replace parts that are damaged, defective, or excessively worn. If replacement of parts is
not practical, replace pump.
SERVICE
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and
gloves and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes and don't breathe vapors. Do not use near open flame or excessive heat.
The flash point is 100 138° F (38 59° C). If you become dizzy while using cleaning
solvent, get fresh air immediately and get medical aid. If contact with eyes is
made, wash your eyes with water and get medical aid immediately.
Clean strainer (13) with drycleaning solvent (Item 10, App C) and dry thoroughly.
2-163
