TM 10-3510-209-24
2-45. DRYER FUEL PUMP ASSEMBLY (CONT)
REMOVAL (Cont)
3.
Open fuel drain valve (1) and relieve fuel
pressure. Close the valve.
WARNING
Failure to cap disconnected fuel lines
could result in fuel being siphoned
onto the ground and equipment.
4.
Remove input fuel line (2) from the fuel filter.
5.
Remove output fuel line (3) and fuel return line
(4). Install line cap in return line.
6.
Remove tee (5) with pressure gage (6) and drain
valve (1) attached.
7.
Remove two bolts (7) and fuel pump (8) from air
intake housing (9).
DISASSEMBLY
NOTE
Early units of this laundry may come equipped with a single-stage pump (J3BA).
For those units, refer to TM 10-3510-208-34 and TM 103510-208-34P for
maintenance.
1.
Remove eight capscrews (10), cover (11), and
gasket (12).
2.
Remove strainer (13) and anti-hum wafer (14).
3.
Remove five screws (15), end plate assembly
(16), spacer plate assembly (17), port housing
(18) and gasket (19).
2-162
