TM 10-3510-209-24
2-44. DRYER COMBUSTION BLOWER AND MOTOR ASSEMBLY (CONT)
REMOVAL (Cont)
5.
Remove eight bolts (5), lockwashers (6) and
motor plate (7) from blower housing (8).
6.
Remove four bolts (9), washers (10), nuts (11),
lockwashers (12), and motor (3) from the dryer.
NOTE
Support the blower housing and fuel
pump while the motor is removed.
7.
Remove motor (3), motor plate (7), and impeller
(13) from blower housing (8).
8.
Loosen setscrew (14) and remove coupling (15)
from the impeller shaft.
9.
Loosen setscrew (16) and remove impeller (13)
from shaft of motor (3).
10.
Remove key (17) from keyway (18) on shaft of
motor (3).
11.
Remove four bolts (19), lockwashers (20) and
motor plate (7) from motor (3).
REPAIR
Repair the combustion blower and motor assembly by replacing damaged or defective components.
INSTALLATION
1.
Position motor plate (7) on new motor (3) and secure with four lockwashers (20) and bolts (19).
2.
Position key (17) in keyway (18) on the shaft of motor (3).
3.
Align motor key (17) and impeller keyway and slide impeller (13) onto the shaft of motor (3).
2-159
