TM 10-3510-209-24
Table 2-2. Unit Troubleshooting (Continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
29.
EXCESSIVE SMOKE FROM DRYER EXHAUST. (Cont)
Step 2.
Check for improper fuel pressure. Pressure should be approximately
100 psi (690 kPa).
a.
If pressure is incorrect, adjust fuel pressure. Refer to
paragraph 2-45.
b.
If fuel pressure is correct, proceed to next step.
Step 3.
Check for dirty burner.
a.
If burner is dirty, clean burner. Refer to paragraph 2-42.
b.
If burner is clean, proceed to next step.
Step 4.
Check for blocked air intake screen.
a.
If blockage is found, remove blockage from air intake screen.
b.
If air intake screen is serviceable, proceed to next step.
Step 5.
Check for worn or broken fuel pump parts.
a.
If pump is damaged, repair or replace fuel pump. Refer to
paragraph 2-45.
b.
If fuel pump is serviceable and problem persists, notify your
supervisor.
30.
AIR LEAKS FROM DRYER DOOR.
Step 1.
Check for loose door latch.
a.
If door latch is loose, adjust or replace door latch. Refer
to paragraph 2-41.
b.
If door latch is serviceable, proceed to next step.
Step 2.
Check for bent door or hinge.
Straighten or replace door assembly. Refer to paragraph 2-41.
2-47
